Hobbyshop247 3.17mm Prop SaverThis handly little device mounts directly to the shaft of your electric motor, and in the event that the prop touches the ground during landing, allows your prop to "pop off" the motor instead of breaking the prop. The prop is held onto the Prop Saver with a small..
Hobbyshop247 5mm Plastic LED HolderDesigned to provide an easy, clean installation of a 5mm LED in any wood, metal, or plastic surface. The LED snaps into the holder, then the assembly is inserted into a 1/4" hole drilled into the mounting surface. Add a couple of drops of CA, or hot glu..
Hobbyshop247 8mm Plastic LED HolderDesigned to provide an easy, clean installation of an 8mm LED in any wood, metal, or plastic surface. The LED snaps into the holder, then the assembly is inserted into a 12mm hole drilled into the mounting surface. Add a couple of drops of CA, or hot gl..
Hobbyshop247 Balance Tap ClipsA nifty little device designed to solve a big problem, these will prevent you from breaking and/or damaging those extremely thin wires the battery manufacturers use for the balance taps on Li-Po, Li-Ion, and LiFe batteries! As we all know, after plugging and unplu..
Hobbyshop247 Battery MinderThis unit is designed to be connected, using a standard servo "Y", to any "active" channel, like the aileron, elevator, or rudder channel. It can also be connected to a spare channel that has been mixed with one of the active channels. Upon power up, ..
Hobbyshop247 Bomb DropThe four modes of release are selected using the red 2-position switch located on the main circuit board as follows: Switches are “Off” when in the down position.Both switches “OFF”- All four bombs are released at once, with a 1-second delay between each release.Switch #1 ..
Hobbyshop247 Brushed DC Motor ControllerThe main circuit board installs anywhere in the model as necessary, it's best to locate it as close to the motor as possible to avoid voltage drops that may occur with long motor wires. The wires that go to the motor and to the power supply are each 24 i..
Hobbyshop247 CF2822-14 1200KV Brushless MotorThis is the replacement motor for our Night Prowler (Night Flyer) ARF. It produces 1200 RPMs per volt of input power (1200KV), and is rated at 204 watts. Recommended prop size is 9-10 inches, and recommended ESC is our 30 amp programmable ESC.Motor ..
Hobbyshop247 CF2822-14 1534KV Brushless MotorThis is the replacement motor for our Night Racer ARF (Night Flyer). It produces 1534 RPMs per volt of input power (1534KV), and is rated at 206 watts. Recommended prop size is 7-8 inches, and recommended ESC is our 30 amp programmable ESC.Motor mou..
Hobbyshop247 Deans Plug (Male) CapA silicone cover for Deans-style T-connectors. These will cover and prevent shorts caused by metal objects coming into contact with the Deans-style connectors on your charging cables. Sold in packs of 3...