Menu
Your Cart

Hobbyshop247

Brand: Hobbyshop247 Model: 2-3S Li-Po Low Voltage Alarm
Hobbyshop247 2-3S Li-Po Low Voltage AlarmThis device can be used as a battery tester, or installed in your electric plane and used as a 2-3S Li-Po alarm.  It features two rows of LEDs, one green, the other red, and an extremely loud piezo buzzer.  The row of pins along the edge are designe..
$4.00
Brand: Hobbyshop247 Model: 2-6s Li-Po Battery Tester
Hobbyshop247 2-6s Li-Po Battery TesterThe connector on this tester is designed to plug directly into a JSH-type balance connector, just position the balance tap so the black, or negative, wire is on the bottom, insert the pins from the tester into it, with the LED display facing you, and it will aut..
$6.00
Brand: Hobbyshop247 Model: 3.17mm Prop Saver
Hobbyshop247 3.17mm Prop SaverThis handly little device mounts directly to the shaft of your electric motor, and in the event that the prop touches the ground during landing, allows your prop to "pop off" the motor instead of breaking the prop.  The prop is held onto the Prop Saver with a small..
$4.00
Brand: Hobbyshop247 Model: 3.5mm 3-Conductor Motor ESC Connector
Hobbyshop247 3.5mm 3-Conductor Motor/ESC ConnectorThis handy little connector contains three 3.5mm Banana Plug and Jack connectors mounted in a single plastic housing for easy disconnecting of all 3 wires at once.  Designed for use on the wires that connect your motor and ESC, this connector ma..
$5.00
Brand: Hobbyshop247 Model: 30 amp Programmable ESC
Hobbyshop247 30 amp Programmable ESCProgrammable Items:1. Brake Setting:Enabled / Disabled, default is Disabled2. Battery Type:Li-xx(Li-ion or Li-poly) / Ni-xx(NiMH or NiCd),default is Li-xx.3. Low Voltage Protection Mode (Cut-Off Mode):Soft Cut-Off (Gradually reduce the output power) or Cut-Off (Im..
$20.00
Brand: Hobbyshop247 Model: 3W 24 LED COB
Hobbyshop247 3W 24 LED COBThe newest in LED technology, these produce a lot of light from a small package.  COB (stands for Chip On Board) feature a number of individual LED chips mounted together on an aluminum substrate, and covered with a silicone dome that seals them in ..
$5.00
Brand: Hobbyshop247 Model: 3W COB LED
Hobbyshop247 3W COB LEDThe newest in LED technology, these produce a lot of light from a small package.  COB (stands for Chip On Board) feature a number of individual LED chips mounted together on an aluminum substrate, and covered with a silicone dome that seals them in and..
$4.00
Brand: Hobbyshop247 Model: 4.0mm Banana Jacks
Hobbyshop247 4.0mm Banana JacksThese are the same banana jacks we use on our 12 volt Power Supplies, they are actually "binding posts", in addition to a male 4mm banana plug they will also accept a bare wire or a U-shaped "fork" connector. There's a small hole drilled through the post just under the..
$2.00
Brand: Hobbyshop247 Model: 4.0mm Banana Plugs
Hobbyshop247 4.0mm Banana PlugsNOTE:  I recommend that you "tin" the wires before inserting them into the jack and tightening the set screw. Strip a small amount of the insulation off the wire, about 1/8", twist the wires together tightly with your fingers, and heat the bare portion of the wire..
$2.00
Brand: Hobbyshop247 Model: 5.5 Watt COB LED
Hobbyshop247 5.5 Watt COB LEDThe newest in LED technology, these produce a lot of light from a small package.  COB (stands for Chip On Board) feature a number of individual LED chips mounted together on an aluminum substrate, and covered with a silicone dome that seals them ..
$4.00
Brand: Hobbyshop247 Model: 5mm LEDs (Pack of 4)
Hobbyshop247 5mm LEDs (Pack of 4)Replacement LEDs for all of our 5mm Navigation Light Sets.  These are the brightest 5mm LEDs we can find anywhere-much brighter than the typical 5mm LED you'll find at your local electronics store.  They are the exact same LEDs we use in production, and can..
$2.00
Brand: Hobbyshop247 Model: 5mm Plastic LED Holder
Hobbyshop247 5mm Plastic LED HolderDesigned to provide an easy, clean installation of a 5mm LED in any wood, metal, or plastic surface.  The LED snaps into the holder, then the assembly is inserted into a 1/4" hole drilled into the mounting surface.  Add a couple of drops of CA, or hot glu..
$1.00
Showing 1 to 12 of 109 (10 Pages)